Spoke Tension Balancer TL-P03 Matrix

Professional Wheel Building Tensiometer Conversion & Radial Analysis

Wheel Configuration & Tool Controls

Drive Side (DS / Right) High Tension
Non-Drive Side (NDS / Left) Dish Dependent

Yellow = Borderline, Red = Out-of-spec

Select variance comparison base

Wheel Balance Status
In Spec (Balanced)
Overall Uniformity
98.5%

Drive Side (DS) Summary

16 / 16 in Spec
Average
120.4 kgf
Min / Max
118 / 123
Std Dev (σ)
1.8
Max Variance
±2.4%

Non-Drive Side (NDS) Summary

16 / 16 in Spec
Average
79.8 kgf
Min / Max
77 / 82
Std Dev (σ)
1.5
Max Variance
±2.8%
Toopre TL-P03 Conversion Note: Intermediate tensiometer readings use piecewise linear interpolation. Drive Side target is shown with solid ring lines on the chart.

Radial Tension Profile & Target Reference Rings

DS NDS

Estimated Vertical (Radial) Deviation Profile

Derived index from DS/NDS tension variance at each spoke-pair position — under-tensioned pairs pull the rim outward (positive / high spot), over-tensioned pairs pull it inward (negative / low spot). This is a calculated estimate, not a measured dial-indicator runout value.

Est. Max Deviation Index
0.0%
--

Dish Balance Simulation — Which Side Pulls Harder

Compares each side's average tension against its own target to estimate which side is pulling the rim off the frame centerline. A modeled estimate — not a substitute for checking with a physical dish gauge.

Est. Dish Offset
0.0%
--
NDS DS Frame Centerline Rim
NDS Pull
0.0 kgf (0% of target)
DS Pull
0.0 kgf (0% of target)

Spoke Tension Readings (Type dial readings; tabbing moves down sequentially)

Drive Side (DS / Right) Spokes

Target: 120 kgf
Spoke # Dial Reading Tension (kgf) Variance Status

Non-Drive Side (NDS / Left) Spokes

Target: 80 kgf
Spoke # Dial Reading Tension (kgf) Variance Status